6 in 1 Vacuum Roller RF Body Contouring Machine | RL600

描述

Six handpieces, and no two of them do the same job.

The RL600 is a floor-standing body contouring tower. Its six applicators split into three groups: three vacuum heads that combine 1MHz bipolar RF with 940nm near-infrared laser, one pure ultrasonic cavitation head, and two roller heads. That split is the point — a shop buying one machine gets a body protocol and a facial protocol out of the same console.

Laser First, Then RF

Every vacuum head in the set fires 940nm near-infrared ahead of the RF. The order is not cosmetic. Near-infrared heats the skin, and heated skin has lower impedance — which means the same 1MHz field reaches deeper. Without that pre-heat, most of a bipolar field stays within a few millimetres of the surface.

The Three Vacuum Heads

No.1 is the large body head for abdomen, flanks and thighs. No.2 is narrower, built for arms and smaller body areas. No.3 is the face and eye head, and it ships with two replaceable tips so the same handle can work the jawline and the periorbital area.

No.1 and No.2 carry their own readouts — 2.4 inch and 1.9 inch — so the operator reads the setting on the handle instead of stepping back to the console mid-protocol.

Vacuum And Rollers Together

Negative pressure runs from 20 to 90 kPa relative, drawing a fold of skin into the chamber rather than pressing flat against it. The rollers then work that fold: 0 to 36 RPM, four roller working modes, and interchangeable sleeves in silicone, POM or metal depending on how much grip the protocol needs.

The geometry is why this works on thin areas. Because the skin is folded into the head, the RF field concentrates inside the fold instead of spreading across the surface — which is how an eyelid can be treated at 1MHz at all.

Cavitation Runs Separate

The cavitation head has no vacuum and no RF. It is the deep-fat applicator: pressure waves break down stubborn fat, and it is the head for the abdomen and flanks when the goal is volume rather than surface.

Built To Be Operated

A 10.4 inch touchscreen on an arm that positions over the client. Pulse mode, width adjustable from 0.5 to 7.5 seconds. Treatment spot sizes are stepped — 4x7mm, 8x25mm, 30x50mm, 40x60mm — so the same head covers a knee and a full flank.

Rated input is 750VA, dual voltage AC110V 60Hz or AC230V 50Hz. The tower measures 625x525x1070mm and ships in a wooden case.

Where It Fits

Salons, spas, body contouring studios and post-partum recovery programmes. Body shaping, circumference reduction, cellulite and stretch marks, skin tightening and face lifting, dark circles and eye bags, lymphatic drainage.

What To Set Expectations At

Circumference change depends on the protocol, the number of sessions and what the client does between them. Vacuum roller work is cumulative — one session produces a temporary result, the programme is what holds it.